HP Xw460c - ProLiant - Blade Workstation Installation Instructions Manual page 6

Step 3—Determine if a low-profile or high-profile Quadro FX 560M board is
installed
In this step, the blade workstation is removed from the rack, and opened to determine what type of Quadro FX
560M graphics card is installed—low-profile or high-profile. Removal of the blade workstation from the rack and
removal of the blade workstation access panel is described in the document HP ProLiant BL460c Server Blade
Maintenance and Service Guide, available at http://www.hp.com/support/xw460c_manuals. Follow the
instructions in the Maintenance and Service Guide to:
1.
Power down the blade workstation.
2.
Remove the blade workstation from the rack.
3.
Remove the blade workstation access panel.
The picture below shows the graphics board that you'll see if a low-profile Quadro FX 560M board is installed. If
your blade workstation has a low-profile Quadro FX 560M board installed, continue with Step 4A.
- 6 -