Linux Red Hat 7 Serial Console Settings - HP Xw460c - ProLiant - Blade Workstation User Manual

Microsoft® enables EMS support in the OS, but EMS support also requires
ROM support. EMS support, when enabled, assumes the serial port for
redirection and may cause interference with other devices attached to the serial
port. To avoid interference, EMS is disabled in the system ROM by default on
ML and DL servers. To enable this feature, Enable Local or Enable Remote must
be selected under the BIOS Serial Console/EMS Support menu in RBSU before
installing Windows® Server 2003. If you install Windows® Server 2003 with
EMS disabled, and later decide to enable it, perform the following steps to update
the boot.ini file:
1. Enable EMS in RBSU.
2. Run bootcfg/ems on/id 1.
3. Reboot.

Linux Red Hat 7 Serial Console Settings

If you are using an HP ProLiant BL e-Class server, each server blade maintains a
connection to COM 1, so they are primarily used remotely through the Integrated
Administrator. To enable BIOS Serial Console for Linux Red Hat 7 OS:
1. Remove the line:
2. Add the following line to the Linux image specification in /ect/lilo.conf:
3. Run /sbin/lilo to make the changes take effect.
4. Add the following line to the end of /etc/inittab to enable agetty on COM1
5. Set SAFE=yes in the file /etc/sysconfig/kudzu, so it does not probe the
6. Add the following line to /etc/securetty to allow root to log in on the ttyS0:
7. Reboot the server blade with these new settings.
HP BIOS Serial Console/EMS Support Settings and Configuration
message=/boot/message from /etc/lilo.conf
Append="console=tty0 console=ttyS0, 115200"
(ttyS0):
7:12345:respawn:/sbin/agetty 115200 ttyS0 vt100
serial port during initialization.
ttyS0
19