HP Xw460c - ProLiant - Blade Workstation User Manual page 87

Using Remote Graphics Software
Rgreceiver.ImageCodec.IsMutable=bool
If set to "1", the image quality can be changed by the user in the Receiver Control
Panel. If set to "0", the user cannot change the image quality. This can be used to
permanently set the image quality before the RGS Receiver is started. The default
value is "1" - image quality can be adjusted by user.
Rgreceiver.ImageCodec.Quality=int
The CodecQuality can be set to a value between and including 0 and 100. This
property is used to set the quality of the image in the Remote Display Window. A
value of 100 is the highest image quality and should be visually lossless. A value of 0
is the lowest image quality. Under most circumstances a value of 65 should be
sufficient. Often, lowering the quality will reduce the bandwidth on the network. The
default value is 65.
Logging Properties:
Rgreceiver.Log.IsMutable=bool
If set to "1", the logging settings in the Receiver Control Panel can be changed by
the user. If set to "0", the user will not be able to change any of the logging settings.
This can be used to permanently enable or disable logging settings before the RGS
Receiver is started. The default value is "1" - logging settings can be changed.
Rgreceiver.Log.IsFileLoggerEnabled=bool
If set to "1", logging output from the RGS Receiver will be sent to a file. The default
value is "1" - log to a file.
Rgreceiver.Log.IsConsoleLoggerEnabled=bool
If set to "1", logging output from the RGS Receiver will be sent to a console window.
The RGS Receiver must be started in a console window to see the logging output.
The default value is "1" - log to the console.
This property only applies to the Linux and HP-UX versions of the RGS Receiver.
Rgreceiver.Log.Filename=string
This is the path to the log file. This will only be used if
RgReceiver.Log.IsFileLoggerEnabled is set to "1". The default path on Windows
is located in the directory where the RGS Receiver is installed, normally C:/Program
Files/Hewlett-Packard/Remote Graphics Receiver/rg.log. The default path on
Linux or HP-UX is $HOME/.hpremote/rgreceiver/rg.log.
Rgreceiver.Log.Level=string
There are five logging levels: DEBUG, INFO, WARN, ERROR and FATAL. If DEBUG
level is chosen, then all level of output from DEBUG to FATAL will be output to the
79