Download Print this page

Configuring The Computer - HP Xw4550 - Workstation - 2 GB RAM Installation Manual

Sas/sata hard drive

Hide thumbs Also See for Xw4550 - Workstation - 2 GB RAM:

Connect the power cable (1) and data cable (2) to the hard drive.

Connect the opposite end of the data cable to the system board or controller card.

CAUTION:

connector on the system board labeled SATA 0 or SAS 0, depending on hard drive type. Connect

a second hard drive to the SATA 1 or SAS 1 connector. Connect a third hard drive to the SATA 2

or SAS 2 connector and a fourth hard drive to the SATA 3 or SAS 3 connector.

Replace the side access panel.

10.

Reconnect any external devices to the computer.

11.

Plug the AC power cord into the computer, then into a grounded AC outlet.

Configuring the computer

NOTE:

The information in the following sections is only applicable if you installed an additional

(second) drive. If you only upgraded the existing hard drive and transferred your data from an old drive

to the new drive, you may skip the procedures on creating partitions unless you encounter problems

upon startup.

ENWW

To avoid any hard drive performance problems, connect the primary hard drive to the

Configuring the computer

Table of Contents