HP VL400 - Vectra - 64 MB RAM User Manual page 28

NOTE
NOTE
NOTE
3 Installing Drivers and Utilities Automatically
How to Perform a Recovery of Drivers and Utilities
6 6 6 6 When you have chosen all the components you wish to install, (check
that your selection is complete) click
installation process.
All the selected drivers and utilities are installed automatically. No
user intervention is required during this process. The status of each
component installation is shown.
If the Windows NT 4.0 Service Pack 6 setup file is detected, you will be
prompted to reinstall the Service Pack. A series of screens will guide you
through this process.
To install certain drivers, it may be necessary for the PC to carry out an
intermediary automatic reboot before the end of the installation
process. When this is necessary, you will be informed in the
progress/status window. The installation process will continue
automatically after the reboot.
L L L L A A A A N N N N C C C C a a a a r r r r d d d d D D D D r r r r i i i i v v v v e e e e r r r r s s s s a a a a n n n n d d d d N N N N e e e e t t t t w w w w o o o o r r r r k k k k P P P P r r r r o o o o t t t t o o o o c c c c o o o o l l l l s s s s
When using the Image Library & Diagnostics CD to install LAN card
drivers, the following network protocols are automatically installed for
each operating system:
Windows 95: NetBEUI + IPX/SPX
Windows 98/2000: TCP/IP (DHCP)
Windows NT 4: NetBEUI.
When LAN drivers are installed, a random hostname is automatically
generated to ensure that there is no conflict with any other PC on the
network.
28
to launch the actual
Next