Connecting To A Novell Netware 5.1 Or 4.11 Server - HP Vectra VL800 Installation Manual

Connecting to a Novell NetWare 5.1 or 4.11 Server

Microsoft Windows NT 4.0 Workstation
Requirements
Operating System
Driver Version
Driver File
Server OS
Client OS
Procedure
1. With the HP Vectra turned off, install the network adapter into an available PCI
slot.
2. Connect the network cable to the newly installed network adapter.
3. Connect the WOL cable between the network adapter and the PC motherboard.
4. Power on the machine and boot to Windows.
5. Logon to Windows with administrator privileges.
6. Click OK to ignore the warning message indicating a driver failed during system
startup. This is caused the removal of the previously installed network adapter.
This message should no longer appear after removing the driver from the
Network properties.
7. The following steps are based on a subsequent installation of Networking on the
system. Adding a network adapter for the first time has some minor differences.
Ask your administrator for more information.
8. Open the Network properties windows to remove a previously installed network
adapter and to add a new one.
9. Click on the "Adapters" tab and highlight the network adapter you want removed
then click on the "Remove" button.
10. Click on the "Adapters" tab then on the "Add" button.
11. Insert the driver disk and click on "Have Disk".
12. Type in the location of the NDIS4 drivers and click on "OK".
13. With "Madge Automated Installation - RECOMMENDED" highlighted, click on
"OK".
Windows NT 4.0 Workstation
6.04
MDGNDIS4.SYS
NetWare 5.1 or 4.11 Server
Client v4.80 for Windows NT/2000