Connecting To A Network - HP s5120f - Pavilion - Slimline Getting Started Manual

Connecting to a Network

This section describes connecting to a network through a wired or wireless connection.
Setting up a wired Ethernet network connection
The Ethernet connection may be called a network interface adapter, network interface card,
or NIC. It provides a high-speed or broadband connection to an Ethernet (10BaseT) or Fast
Ethernet (100BaseT) network. After you connect this interface to a network, such as a LAN,
you can connect to the Internet through the network.
1 Connect an Ethernet cable to the Ethernet (RJ-45) connector (A) on the back of the
computer, and to the network router or LAN device.
2 With the computer turned on, check the indicator lights (B) next to the Ethernet connector
for the status:
ACTIVITY — Lit yellow during network data transfer activity
LINK — Lit green when there is a valid network connection
NOTE: Your Ethernet connector may have only one indicator light.
Setting up a wireless network connection
(Select models only)
You can connect the computer to a wireless network supporting IEEE 802.11b, 802.11g, or
802.11n (select models only) by using the antenna that is included with the computer.
Connect the external antenna to the wireless antenna connector on the network card to
increase the range and sensitivity of the wireless radio signal.
NOTE: For the best wireless performance, place the antenna on the computer or in an
elevated and open area.
You need an existing wireless LAN with an Internet connection. Consult your Internet Service
Provider (ISP) for further information.
To verify that the integrated WLAN device is installed on the computer correctly, see
"Checking the wireless LAN device installation" on page 19.
For more information about setting up a wireless network: Click the Windows Vista start
button™ on the taskbar, click Help and Support, and then type Setting up a wireless
network into the Search Help box and press Enter.
Setting Up Your Computer 7