Table of Contents
Advertisement
28
•
If Disk Manager has installed the DDO on your hard drive and
you have booted directly from a diskette, the information in the
boot record for the drive may not have been loaded. Make sure
there is no diskette in drive A and reboot. If you want to boot
from the diskette, follow the "Booting with a Diskette" instruc-
tions under "Advanced Disk Manager options" on page 20.
The dealer partitioned and formatted the drive for you in the
store, but the drive does not respond when you install it.
•
Reboot the computer and make sure the drive spins up. Check
all cables.
•
Make sure the power supply is adequate for system needs.
•
Make sure the DOS version the dealer used to partition and
format the drive is the same version you have installed in your
computer. If it isn't, see your dealer.
•
Verify the drive-type values in the system setup program. You
must install the drive using the same drive-type values your
dealer used to partition the drive.
•
Check for I/O address conflicts between peripheral cards.
•
Check for viruses.
The system hangs in FDISK or fails to create or save the
partition record.
•
Check all cables.
•
Your DOS diskette may be corrupted. Try using a backup DOS
diskette.
•
Make the partitions smaller.
•
Change the interrupt jumper setting on the host adapter.
Medalist 4342, 3232 and 2122, Rev. C
Advertisement
Table of Contents
