Solving Power Problems - HP Pro 3330 Maintenance And Service Manual

System does not power on and the LEDs on the front of the computer are not flashing.
Cause
System unable to power on.

Solving Power Problems

Common causes and solutions for power problems are listed in the following table.
Table D-2 Solving Power Problems
Power supply shuts down intermittently.
Cause
Voltage selector switch on rear of computer chassis (some
models) not switched to correct line voltage (115V or 230V).
Power supply will not turn on because of internal power
supply fault.
Solution
Press and hold the power button for less than 4 seconds. If
the hard drive LED turns green, then:
1. Check that the voltage selector, located on the rear of
the power supply on some models, is set to the
appropriate voltage. Proper voltage setting depends on
your region.
2. Remove the expansion cards one at a time until the
5V_aux light on the system board turns on.
3. Replace the system board.
OR
Press and hold the power button for less than 4 seconds. If
the hard drive LED does not turn on green then:
1. Check that the unit is plugged into a working AC outlet.
2. Open hood and check that the power button harness is
properly connected to the system board.
3. Check that both power supply cables are properly
connected to the system board.
4. Check to see if the 5V_aux light on the system board is
turned on. If it is turned on, then replace the power
button harness.
5. If the 5V_aux light on the system board is off, then
replace the power supply.
6. Replace the system board.
Solution
Select the proper AC voltage using the selector switch.
Contact an authorized service provider to replace the power
supply.
Solving Power Problems 155