Replacing Or Adding A Drive - Compaq Presario SR1300 - Desktop PC Manual

5 Pull the drive out of the drive bay.
6 If you are replacing the old drive with a new drive,
remove the four guide screws (two on each side)
from the old drive. You need these screws to install
the new drive.

Replacing or Adding a Drive

1 If necessary, remove the existing drive.
See "Removing a Drive" on page 3.
2 If you are adding a drive to an empty lower optical
drive bay, you must remove the blank plate from
the bay. To do so, insert a flat screwdriver into the
blank plate slot (C) and rotate the screwdriver to
break the blank plate out of the chassis. Discard the
blank plate.
3 Make sure the jumper on the new optical drive or
new Parallel ATA hard disk drive is in the CS
(Cable Select) position. Your drive may vary from
the illustration. The Serial ATA hard disk drive does
not use cable select.
Cable Select Jumper
4 Install four guide screws on the sides of the new
drive (two on each side). The screws help guide the
drive into its proper position in the bay.
5 Slide the drive partway into the drive bay, making
sure to align the guide screws with the guide slots.
6 Reconnect the power and data cables to your
drive, as indicated in the following illustrations. If
it is present, reconnect the sound cable.
Connecting the Optical Drive Cables
An optical drive may include a sound cable.
NOTE:
Connect this cable also.
Connecting the Memory Card Reader Drive
Cable
Upgrading and Servicing Guide
5