Advertisement
Frequency Response:
Microphone Use and Placement
Please note that micing techniques are a matter of personal
preference. These are merely guidelines to assist in the
placement of the microphone to gain optimal performance.
Usage
Optimal Placement
Electric Guitar and
Bass Guitar Amplifier
Place microphone approximately 1 to 2 inches from and at a 90° angle to the speaker cone. To reduce
boominess, move the microphone off axis to the cone from 90° to 45°, or move mic from center of cone to
either edge.
On double headed Toms, place mic 1 to 3 inches over the top of drum, at a 45° angle to the drum surface,
Tom-Toms
and 1 to 2 inches in from the drum edge. On single headed Toms, use above method or place mic inside
Tom from underneath at a 90° angle from the center of head, 3 to 5 inches away.
Snare Drum
Place mic 1 to 3 inches above the top head, 1 to 2 inches in from the rim. Aim the mic downward at an
angle toward the top head. If the drum rings, tape deadening material to the head or use damping rings.
For more "snare" sound, place a 2nd mic underneath aimed up at the bottom of head.
Cymbals
Place mic 1 to 2 feet above the top of cymbals.
Place mic 5 inches above outside edge at a 45° down angle.
High-Hat
Place mic 6 to 24 inches away, and on axis with the bell of the instrument.
Brass
Place mic 6 to 12 inches from where finger board joins the body.
Acoustic Guitar
Standard Placement & Use Guidelines
1. Always point the microphone at the desired source of sound, and away from any unwanted sources.
2. The microphone should be located close to the sound source to minimize interference from other potential sound sources.
3. Use the 3-to-1 rule when using multiple microphones. Place each microphone three times farther from other microphones as from
the desired sound source.
4. Minimize over-handling of the microphone to reduce unwanted mechanical noise.
Dimension
Drawing:
Electro-Voice
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Bosch Communications Systems
Part Number LIT000247 Rev B
®
08/2008
Polar Response:
PL35 Part Numbers
•
PRD000164000
PL35, Dynamic Supercardioid Snare/Tom
Microphone
•
ACC000044000
DRC-1, Replacement Clip-on Drum Rim
Clamp
•
ACC000050001
WSPL-3, Optional Foam Windscreen, Black
U.S.A. and Canada only. For customer orders, contact Customer Service at:
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
Other Internatonal locations. For customer orders, Contact Customer Service at:
For warranty repair or service information, contact the Service Repair department at:
For technical assistance, contact Technical Support at: 866/78AUDIO
800/392-3497 Fax: 800/955-6831
+ 49 9421-706 0 Fax: + 49 9421-706 265
+ 1 952 884-4051 Fax: + 1 952 887-9212
800/685-2606
Specifications subject to change without notice.
Advertisement
