Removing And Reinstalling The Front Bezel; Installing Or Replacing A Pci Card - Lenovo ThinkCentre A62 User Manual

Removing and reinstalling the front bezel

This section provides instructions on how to remove and reinstall the front bezel.
To remove and reinstall the front bezel:
1. Remove all media from the drives and turn off all attached devices and the
2. Remove the computer cover. See "Removing the computer cover" on page 16.
3. Remove the front bezel by releasing the three plastic tabs on the left side and
Figure 7. Removing the front bezel
4. To reinstall the front bezel, align the plastic tabs on the right side of the front
5. To complete the installation, go to "Completing the parts replacement" on page

Installing or replacing a PCI card

This section provides instructions on how to install or replace a PCI card. Your
computer has two standard PCI card slots, one PCI Express x1 card slot, and one
PCI Express x16 graphics card slot.
18
User Guide
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
pivoting the front bezel outward. Carefully set the front bezel to the side
without disconnecting the power switch and LED assembly cable.
bezel with the corresponding holes in the chassis, then pivot the front bezel
inward until it snaps into position on the left side.
45.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support