Asus P4B266 User Manual page 45

9. Line out selector (two 2-pin LO_L, LO_R) (on audio models only)
By default, these jumpers are shorted (jumper caps on) to route the
signal from the audio controller to the rear panel Line Out jack to make
it available for audio out devices such as speakers or a headphone. If
you connect the Intel Front Panel audio cable to the IAPANEL
connector (see page 2-32 for the location), remove the caps from
these jumpers to allow automatic switching of audio signal between the
rear panel Line Out jack and the Intel audio cable.
®
P4B266
P4B266 Internal Line Out Connectors
10. Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)
These jumpers allow you to select the speaker output for a 6-channel
audio system. No audio standard exists for the three pick-up surfaces
on male audio ports, so it is necessary to switch the jumpers from the
default position CENTER/BASS (pins 2-3) to BASS/CENTER (pins
1-2) to re-route signals on the internal leads of the Mic port.
Use the audio driver included in the support CD to install the multi-
channel audio feature. See section "5.3 Software information."
®
P4B266
P4B266 Bass Center Setting
ASUS P4B266 motherboard user guide
LO_L
BLOL
FLOL
LO_R
BLOR
FLOR
BCS
BCS1 BCS1
BCS2 BCS2
1 2
(BASS/CENTER) (CENTER/BASS)
2 3
(Default)
2-23