Table of Contents
Advertisement
3. HARDWARE SETUP
31) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
Make sure that your ATX power supply can supply at least 10mA
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
1
P3W-E
®
P3W-E ATX Power Connector
32) Thermal Sensor Connector (2-pin JTPWR)
If you have a power supply with thermal monitoring, connect its thermal sensor
cable to this connector.
1
P3W-E
®
P3W-E Thermal Sensor Connector
46
1
0
1
0
Power Supply On
JTPWR
1
0
1
0
Power Supply
Thermal Sensor Connector
ASUS P3W-E User's Manual
+3.3Volts
+3.3 Volts
-12.0Volts
+3.3 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
+5.0 Volts
Ground
Ground
-5.0 Volts
Power Good
+5.0 Volts
+5V Standby
+5.0 Volts
+12.0Volts
Advertisement
Table of Contents
