Table of Contents
Advertisement
3. HARDWARE SETUP
14) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (not required for onboard LAN model). The
connector powers up the system when a wakeup packet or signal is received
through the LAN card.
IMPORTANT:
(see 4.5.1 Power Up Control) and that your system has an ATX power supply
with at least 720mA +5V standby power.
1
P3W-E
®
P3W-E Wake-On-LAN Connector
15) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT:
Enabled (see 4.5.1 Power Up Control).
1
P3W-E
®
P3W-E Wake-On-Ring Connector
40
This feature requires that Wake On LAN is set to Enabled
1
0
1
0
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
This feature requires that PWR Up On Modem Act is set to
1
0
1
0
Ground
ASUS P3W-E User's Manual
Ground
PME
+5 Volt Standby
WOL_CON
1
2
RI#
WOR
Advertisement
Table of Contents
