Asus P2E-N User Manual page 27

III. INSTALLATION
11. Primary IDE Connector (40-1 pin IDE)
This connector supports the provided IDE hard disk drive ribbon cable. After
connecting one end to the riser card, connect the other end to a hard disk drive.
The primary IDE channel supports both a master and a slave IDE device but the
system housing size only permits a standard IDE hard drive to be installed.
IDE (Hard Disk Drive) Connector
12. 3.5inch Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the riser card, connect the other end to a 3.5inch floppy disk
drive.
Floppy Disk Drive Connector
13. LAN Activity Connectors (2 pin LAN_LED & 3 pin WOL_CON)
These connectors support Local Area Network (LAN) cards such as the ASUS
PCI-L101 with output signals for data transfer activity. The LAN_LED connec-
tor allows the front panel LED to blink during transfer activity between the
network and the computer. The WOL_CON connector allows the system to power
up when there is a wakeup package (signal) received from the network.
LAN Activity Connectors
ASUS P2L-N/P2E-N User's Manual
Riser Card Front
Floppy Drive Conn.
Riser Slot
Panel Conn.
Riser Card Front
Riser Slot
Primary IDE Connector
Pin 1
Orient the red stripe on the
IDE ribbon cable to Pin 1
Pin 1
Orient the red stripe on the
floppy ribbon cable to Pin 1
LAN activity LED
Wake on LAN activity
27