Asus P2B-D User Manual page 15

III. INSTALLATION
Set the jumpers by the Internal speed of your processor as follows:
Intel CPU Model Freq.
Pentium III 600MHz
Pentium III 550MHz
Pentium III 500MHz
Pentium III/II 450MHz
Pentium II 400MHz
Pentium II 350MHz
Pentium II 333MHz
Pentium II 300MHz
Pentium II 266MHz
Pentium II 233MHz
For updated processor settings, please visit ASUS' web site (see ASUS CONTACT INFORMATION).
NOTES: Overclocking your processor is not recommended. It may result in a slower
speed. Voltage Regulator Output Selection (VID) is not needed for the Pentium III/
II processor because it sends a VID signal directly to the onboard power controller.
5. Chassis Intrusion Sensor Setting (JP18) (optional/reserved)
This allows you to disable or enable the chassis intrusion sensor. Set to Enable if
you want to use this function to monitor intrusion into your computer, for ex-
ample, when the drive bay doors are opened. The default is set to Disable.
P2B-D/DS Chassis Intrusion Sensor Setting
ASUS P2B-D/P2B-DS User's Manual
(Bus Freq.)
Mult. Bus F. FS2 FS1 FS0
6.0x 100MHz [1-2] [1-2] [1-2]
5.5x 100MHz [1-2] [1-2] [1-2]
5.0x 100MHz [1-2] [1-2] [1-2]
4.5x 100MHz [1-2] [1-2] [1-2]
4.0x 100MHz [1-2] [1-2] [1-2]
3.5x 100MHz [1-2] [1-2] [1-2]
5.0x 66MHz [2-3] [1-2] [1-2]
4.5x 66MHz [2-3] [1-2] [1-2]
4.0x 66MHz [2-3] [1-2] [1-2]
3.5x 66MHz [2-3] [1-2] [1-2]
JP18
Disable
(Default)
(Freq. Mult.)
BF3 BF2 BF1 BF0
[1-2] [2-3] [2-3] [2-3]
[2-3] [1-2] [1-2] [1-2]
[2-3] [1-2] [1-2] [2-3]
[2-3] [1-2] [2-3] [1-2]
[2-3] [1-2] [2-3] [2-3]
[2-3] [2-3] [1-2] [1-2]
[2-3] [1-2] [1-2] [2-3]
[2-3] [1-2] [2-3] [1-2]
[2-3] [1-2] [2-3] [2-3]
[2-3] [2-3] [1-2] [1-2]
JP18
Enable
15