Asus P2B-B User Manual page 31

III. INSTALLATION
16. USB, Infrared, PS/2 Mouse Module Connector (18-1 pin USB/MIR)
If you want to use USB or infrared (IrDA) devices, you need to purchase an
external connector set. Otherwise, a PS/2 mouse connector is provided with the
parallel connector. The external connector set, which also includes a PS/2 mouse
connector, connects to the 18-pin block and mounts to an open slot on your
computer's chassis. The system will direct IRQ12 to the PS/2 mouse if one is
detected. If not detected, expansion cards can use IRQ12. See PS/2 Mouse Con-
trol in BIOS Features Setup and USB Function in PnP and PCI Setup of the
BIOS SOFTWARE. See Second IrDA... connector for details on the infrared
connector.
P2B-B PS/2 Mouse, USB, IrDA Module Connector
17. IrDA-Compliant infrared module connector (5-pin IR)
This connector supports the optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support this
feature. You must also configure the setting through "UART2 Use Infrared" in
Chipset Features Setup to select whether UART2 is directed for use with COM2
or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable
from the module to the motherboard according to the pin definitions.
P2B-B Infrared Module Connector
1 9
18
10
1: USB +5 Volt
2: USB Port 0 -
3: USB Port 0 +
4: Ground
5: (no connection)
6: PS/2 Mouse Clock
7: Ground
8: (no connection)
9: +5 Volt
ASUS P2B-B User's Manual
USB/MIR
Parallel Connector
PS/2 Mouse Connector
10: USB +5 Volt
11: USB Port 1 -
12: USB Port 1 +
13: Ground
14: (no connection)
15: PS/2 Mouse Data
16: Ground
17: Infrared Receive
18: Infrared Transmit
Optional USB/MIR
Back View
Front View
+5V
IRTX
GND
(NC)
IRRX
Infrared
PS/2
Mouse
USB 0
USB 1
31