Kyocera FS-C5100DN Advanced Operation Manual page 14

1-8
Transparency
Transparencies must be able to withstand the heat of fusing during the
printing process. The recommended transparency product is 3M CG3700
(Letter, A4).
The table below lists the specifications for transparency:
Item
Tolerance of heat
Thickness
Material
Dimensional accuracy
Squareness of corners
To prevent printing problems,
feed transparencies into the
printer one sheet at a time
from the MP tray. Always load
the transparencies vertically
(with the long edge towards
the printer).
If the transparencies have
rough edges on the back, it
may cause a paper jam.
Remove the rough edges,
reverse the sides or feed the
sheet from the opposite edge.
When unloading transparencies (e.g., for clearing jams), hold them
carefully by the edges to avoid leaving fingerprints on them.
Specification
Must tolerate at least 190 °C (374 °F)
0.100 to 0.110 mm (3.9 to 4.3 mils)
Polyester
±0.7 mm (±0.0276 inches)
90° ±0.2°
Handling Paper