Pc Adjust Status Read Command; Cr_Fsync Command; Cr_Tdots Command; Cr_Clpphase Command - Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications

9.5 PC Adjust Status Read Command

9.5.1

CR_FSYNC Command

Command "CR_FSYNC" [CR]
Details Get value of Fine Sync
Acceptable
%1
Response
Unacceptable
9.5.2

CR_TDOTS Command

Command "CR_TDOTS" [CR]
Details Get value of Total Dots
Acceptable
%1
Response
Unacceptable
9.5.3

CR_CLPPHASE Command

Command "CR_CLPPHASE" [CR]
Details Get value of Clamp Phase value
Acceptable
Response
%1
Unacceptable
9.5.4

CR_H-POS Command

Command "CR_H-POS" [CR]
Details Get value of Horizontal Position
Acceptable
%1
Response
Unacceptable
9.5.5

CR_V-POS Command

Command "CR_V-POS" [CR]
Details Get value of Vertical Position
Acceptable
%1
Response
Unacceptable
"000_%1" [CR]
"0000 – 0031"
"Error Code" [CR] --- When command is not available in the given
condition (such as being selected input)
"?" [CR] --- When unknown command is received
"000_%1" [CR]
"mmmm" – "nnnn"
(mmmm = Display area H + Position H)
(nnnn = Maximum value less than 140 MHz of Dot Clock)
"Error Code" [CR] ------------------------ When command is not
available in the given condition (such as being selected input
"?" [CR] ------------------- When unknown command is received
"000_%1" [CR]
"0000 – 0255"
"Error Code" [CR]
"000_%1" [CR]
"0000 – nnnn"
(nnnn = Total Dots – Display area H)
"Error Code" [CR] ------ When command is not available in the
given condition (such as being selected input
"?" [CR] ------------------- When unknown command is received
"000_%1" [CR]
"0000 – nnnn"
(nnnn = Total Line – Display area V)
"Error Code" [CR] ------ When command is not available in the
given condition (such as being selected input
"?" [CR] --------------------- When unknown command is received
64/94