Using The Magnify Feature - Hitachi CP-X2514WN Operating Manual

Operating

Using the magnify feature

1.
Press the MAGNIFY ON button on the remote control.
The picture will be magnified, and the MAGNIFY dialog
will appear on the screen. When the MAGNIFY
ON button is pressed for the first time after the
projector is turned on, the picture will be zoomed
by 1.5 times. On the dialog, triangle marks to show
each direction will be displayed.
2.
The display magnification of the projector switches in order with every press
of the MAGNIFY ON button.
 For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B port
1.5 times  2 times  3 times  4 times  1 time
 For video signals, s-video signals, component video signals or
HDMI (Component) signals
TM
1.5 times  2 times  1 time
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magnification.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnification is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnification is active, the keystone distortion condition may vary.
It will be restored when the magnification is disabled.
● Some horizontal stripes might be visible on the image while magnification is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
26
(RGB) signals, input signals from the
TM
MAGNIFY
ON/OFF button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH BLANK
FREEZE
MAGNIFY PAGE VOLUME
UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE MUTE
MENU
POSITION
ENTER
ESC RESET