Maintenance; Inspecting And Cleaning The Strainer; Cleaning; Model Bag - HP Designjet 3D User Manual

5

Maintenance

Inspecting and cleaning the strainer

The strainer at the bottom of the cleaning tank should be cleaned before every use of the system
to maintain optimal system performance. Remove the strainer from the cleaning tank and rinse
under water until the strainer is clean. Place the strainer back in the cleaning tank after cleaning.

Cleaning

The system should be cleaned once a month or sooner as needed. Clean the exterior and the
interior of the cleaning tank with mild soap and water using a sponge or cloth only. Hard to
remove residue can be cleaned with isopropyl alcohol. Never immerse the system or use a spray
nozzle or hose to clean it. Any liquid in the electronics area behind the back panel of the system
may damage the system and void the warranty.

Model bag

The model bag should be replaced after 40 cycles. Replace the bag if the elastic cord starts to
droop or the bag shows signs of wear.
Inspecting and cleaning the strainer 13