Real-Time Clock, Cmos Sram, And Battery; Pci Express* Connectors - Intel BOXD945PAWLK - Desktop Board D945PAW Manual

NOTE
Many Serial ATA drives use new low-voltage power connectors and require adaptors or power
supplies equipped with low-voltage power connectors.
For more information, see:
For information about
The location of the Serial ATA IDE connectors

1.6.3 Real-Time Clock, CMOS SRAM, and Battery

A coin-cell battery (CR2032) powers the real-time clock and CMOS memory. When the computer
is not plugged into a wall socket, the battery has an estimated life of three years. When the
computer is plugged in, the standby current from the power supply extends the life of the battery.
The clock is accurate to ± 13 minutes/year at 25 ºC with 3.3 VSB applied.
NOTE
If the battery and AC power fail, custom defaults, if previously saved, will be loaded into CMOS
RAM at power-on.

1.7 PCI Express* Connectors

The board provides the following PCI Express connectors:
•
One PCI Express x16 connector supporting simultaneous transfer speeds up to 8 GBytes/sec
•
One PCI Express x1 connector. The x1 interface supports simultaneous transfer speeds up to
500 MBytes/sec
The PCI Express interface supports the PCI Conventional bus configuration mechanism so that the
underlying PCI Express architecture is compatible with PCI Conventional compliant operating
systems. Additional features of the PCI Express interface include the following:
•
Support for the PCI Express enhanced configuration mechanism
•
Automatic discovery, link training, and initialization
•
Support for Active State Power Management (ASPM)
•
SMBus 2.0 support
•
Wake# signal supporting wake events from ACPI S1, S3, S4, or S5
•
Software compatible with the PCI Power Management Event (PME) mechanism defined in the
PCI Power Management Specification Rev. 1.1
http://www.serialata.org/
Product Description
Refer to
Figure 17, page 48
23