Connections; Audio Out Terminals Connection - Panasonic TH-103PF9UK - 103" Plasma Panel Operating Instructions Manual

Connections

AUDIO OUT Terminals connection

Speakers (Optional accessories)
AC cord connection (see page 13)
– AC cord fi xing
Note:
Make sure that the AC
cord is locked.
– Cable fi xing bands – Cable fi xing bands
Secure any excess cables with bands as required. Secure any excess cables with bands as required.
Pass the attached cable Pass the attached cable
fi xing band through the fi xing band through the
clip as shown in the clip as shown in the
fi gure. fi gure.
1
SLOT1
Optional Terminal DVI-D IN DVI-D IN
Board Insert Slot Terminals
Terminals
(covered) (see page 12)
(see page 12)
Note:
At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3
AC cord connection (see page 13)
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2 Fix the AC cord with
the clamper.
To secure cables connected to Terminals, wrap the cable fi xing band around them then To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure. pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band. in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
AUDIO
DVI-D IN
SLOT2
COMPONENT/RGB IN COMPONENT/RGB IN
and Audio IN Terminals
and Audio IN Terminals
(see page 12)
(see page 12)
Close
Push until
the hook clicks.
Open
2. Pull off.
1. Keep the
To tighten: To tighten:
Pull
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
Optional Terminal From EXTERNAL From EXTERNAL
monitor terminal on
Board Insert Slot monitor terminal on
Computer (see page 10)
(covered) Computer (see page 10)
R L
AUDIO OUT
Stereophonic sound code
audio equipment
line-in
Unplug the AC cord
Close
Open
Unplug the AC cord pressing
the two knobs.
knob pressed.
To loosen: To loosen:
Push the catch Push the catch
Pull
Pull
AUDIO
PC IN SERIAL
From SERIAL From SERIAL
Terminal on Computer
Terminal on Computer
(see page 11)
(see page 11)
R L
AUDIO OUT
From input on
audio amplifi er
(see page 9)
9