Nokia E72 User Manual page 147

802.1x authenticates and authorizes devices to access a
wireless network, and prevents access if the authorization
process fails.
Select WLAN security settings
WPA/WPA2 — Select EAP
Protocol) or Pre-shared key
identification).
EAP plug-in settings — If you selected
EAP, select which EAP plug-ins defined in your device to
use with the access point.
Pre-shared key — If you selected
shared key, enter the shared private key that identifies
your device to the WLAN to which you connect.
WPA security settings
Select WPA/WPA2 as the WLAN security mode.
Select WLAN security settings
WPA/WPA2 — Select EAP
Protocol) or Pre-shared key
identification).
EAP plug-in settings — If you select
EAP, select which EAP plug-ins defined in your device to
use with the access point.
Pre-shared key — If you select
shared key, enter the shared private key that identifies
your device to the WLAN to which you connect.
WPA2 only mode — To allow both TKIP and AES
(Advanced Encryption Standard) encryption, select Off. To
allow AES only, select On
and from the following:
(Extensible Authentication
(a secret key used for device
WPA/WPA2
WPA/WPA2 Pre-
>
and from the following:
(Extensible Authentication
(a secret key used for device
WPA/WPA2
WPA/WPA2 Pre-
>
Wireless LAN plugins
Select Menu
>
Destinations, and an access point group.
The extensible authentication protocol (EAP) plug-ins are
used in wireless networks to authenticate wireless devices
and authentication servers, and the different EAP plug-ins
make possible the use of various EAP methods (network
service).
>
You can view the EAP plug-ins currently installed in your
device (network service).
EAP plug-ins
1 To define the EAP plug-in settings, select
New access point
uses WLAN as a data bearer.
2 Select 802.1x
3 Select WLAN security settings
EAP EAP plug-in
>
Use EAP plug-ins
>
To use an EAP plug-in when you connect to a WLAN using
the access point, select the desired plug-in and
Options > Enable. The EAP plug-ins enabled for use with
this access point have a check mark next to them. To not
use a plug-in, select
To edit the EAP plug-in settings, select
Ctrl. panel Settings and
>
and define an access point that
or WPA/WPA2 as the security mode.
WPA/WPA2
>
settings.
Options > Disable.
Options
Connection
>
Options
>
>
> Edit.
147