Acer 5530 5634 - TravelMate - Athlon X2 2.1 GHz Service Manual page 41

Parameter
On chip SATA
SATA Class ID
SATA IDE
Combined mode
PATA Channel
Config
ACHI ROM
POST delay
USB Host
Controller
Legacy USB
Support
Option ROM
Placement
Large Disk
Access Mode
Installed O/S
Reset
Configuration
Data
Processor
Assisted
Virtualization
Chapter 2
Description
Enable On chip SATA.
Select the SATA Class ID.
Set SATA IDE Combined mode.
Set the SATA channel as Primary or
Secondary channel.
Select SATA option ROM POST delay.
Enable or disable USB hardware.
Enable support for Legacy Universal Serial
Bus.
Determines which peripheral devices can
be booted.
NOTE: Changes to this setting can cause
the system to halt during boot.
Set the Large Disk Access mode. Different
O/S require different drive geometry
representations. Select Other for UNIX,
Novell NetWare, or other O/S.
Set the most commonly used O/S on the
system.
Clear Extended System Configuration Data
(ESCD) area.
Enable the hardware visualization support.
Submenu Items
Option: Enabled or Disabled
Option: IDE-ACHI Class,
HyperFlash Class, IDE-HyperFlash
Class, IDE Native Mode, Raid Class,
ACHI Class, or IDE Legacy Mode
Option: Disabled or Enabled
Option: SATA as primary or SATA
as secondary
Option: Disabled, 7, 6, 5, 4, 3, 2, or
1 second(s) delay
Option: Enabled or Disabled
Option: Enabled or Disabled
Option: Disabled, Temporary, or
E000 Extend
Option: DOS or Other
Option: Other, Win2000, WinMe,
Win98, or Win95
Option: No or Yes
Option: Enabled or Disabled.
31