General Troubleshooting; Caution For Using Ezsign 2.0 - LG 42LT560C Quick Reference Manual

20
GENERAL TROUBLESHOOTING / CAUTION FOR USING EZSIGN 2.0

GENERAL TROUBLESHOOTING

Display Panel Picture
Symptom
No picture.
Picture Reception
Symptom
Normal picture,
poor or no sound.

CAUTION FOR USING EzSIGN 2.0

For 32/37/42/47LT560E
Do not remove a USB drive while data is being copied. It can corrupt the data and EzSign may not work properly.
y y
While loading a USB device or dongle, your TV may function slower than normal.
y y
While EzSign contents is running, the movie with internal subtitles is not supported in USB mode. EzSign TV supports
y y
only external subtitles.
(External Subtitle format: *.smi/*.srt/*.sub(MicroDVD, Subviewer 1.0/2.0)/*.ass/*.ssa/*.txt(TMPlayer)/*.psb(PowerDivx)
Some user-created subtitles may not work properly.
y y
Some special characters are not supported in subtitles.
y y
HTML tags are not supported in subtitles.
y y
Subtitles in languages other than the supported languages are not available.
y y
EzSign 2.0 TV function does not work before completing the initial setup Wizard. Make sure to complete the initial
y y
setup Wizard by turning on the TV after installation.
If the time is set according to the TV signal, it may not appeared exactly for some region. In that case, set the time
y y
manually.
It is recommended that you copy files to the TV memory before playing them, as playing directly from the USB
y y
memory for an extended period of time may cause the device to overheat.
In EzSign 2.0 TV mode, some remote control keys may not work.
y y
EzSign 2.0 TV dose not support the USB HUB. It is recommended that you connect a USB device directly to the TV
y y
without using a USB extension cable as it may not work properly.
It is recommended that you use EzSign 2.0 TV within 8 hours per day as it is standard.
y y
Refer to the EzSign 2.0 Editor user guide for details.
y y
Possible Cause(s)
Display panel is turned off.
y y
Antenna/cable not connected.
y y
Connections incorrect.
y y
MPI not connected
y y
Encrypted program.
y y
Wrong tuning band.
y y
Possible Cause(s)
Wrong Installer Menu settings.
y y
Broadcast problem.
y y
Possible Solution(s)
Turn TV ON.
y y
Power failure?
y y
Connect antenna/cable signal to TV.
y y
Check connections on TV.
y y
If applicable, connect MPI cable to MPI device.
y y
Try another channel.
y y
Adjust Installer Menu settings.
y y
Possible Solution(s)
Press MUTE or use Volume Up key to increase
y y
sound level.
Try a different channel.
y y