Appendix
Distorted sound.
Are the effect settings appropriate?
Use of certain effects at certain settings may produce distortion.
[EDIT] Select "02:Part" [ENTER] Select "05:Voice Insert Eff"/"05:DrumKit Insert Eff" [ENTER]
Are the filter settings appropriate?
Excessively high filter resonance settings can cause distortion.
[EDIT] Select "02:Part" [ENTER] Select "02:Filter/EG" [ENTER]
Are any of the following volume parameters set so high that clipping is occurring?
[UTILITY] [EDIT] Select "01:Common" [ENTER] Select "05:General" [ENTER] "Volume"
[PART SELECT] "Volume"
[UTILITY] Select "01:General" [ENTER] "WAV Volume"
Sound is cut off.
Is the entire amount of notes played (via your keyboard playback and Song/Pattern/Arpeggio playback) exceeding the maximum
polyphony of this instrument?
The maximum number of simultaneous notes may be less than 128 depending on the Voices used.
Only one note sounds at a time.
When this situation occurs, the Mono/Poly parameter in the current mode is set to "mono." If you wish to play chords, set this parameter
to "poly."
[EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "Mono/Poly"
Pitch or intervals are wrong.
Is the Master Tune parameter in the Utility display set to a value other than "0"?
[UTILITY] Select "01:General" [ENTER] "Tune"
Is the Note Shift parameter in the Utility display set to a value other than "0"?
[UTILITY] Select "01:General" [ENTER] "NoteShift"
Are the Note Shift and Detune parameters of each Part set to values other than "0"?
[EDIT] Select "01:Part" [ENTER] Select "01:PlayMode" [ENTER] "NoteShift"/"Detune"
No effect is applied.
Check the on/off status of the Insertion Effect switch.
[EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "InsSw"
[PART SELECT] "InsSw"
Is the Reverb Send or Chorus Send set to a value other than "0"?
[EDIT] Select "02:Part" [ENTER] Select "01:PlayMode" [ENTER] "ChoSend"/"RevSend"
Has the Insertion Effect type for the Part been set to "thru"?
[EDIT] Select "02:Part" [ENTER] Select "05:Voice Insert Eff"/"05:DrumKit Insert Eff" [ENTER]
The Edit Indicator appears, even when parameters are not being edited.
Keep in mind that even though the Edit mode is not active, simply moving a Knob or playing back the MIDI data of the USB flash
memory may cause the Edit Indicator to appear.
42
MX49/MX61 Owner's Manual