Sample Rate - Yamaha mLAN Installation Manual

EXIT .........................Disables mLAN Driver, then removes
the mLAN Driver icon from the task
bar. To display the driver icon on the
task bar again, from the Start menu,
select [(All) Programs] → [Startup]
→ [mLAN Manager]. If Auto On is set
to "On," mLAN Driver is automati-
cally enabled.
NOTE
• The default setting of Auto On for mLAN Driver is "On," which
allows the computer to automatically enable mLAN Driver at
startup.
• You can use Driver Setup to check whether data is being properly
transmitted and received.
Device Manager (Operating System)
When using Windows XP
1
Select [Control Panel] from the Start menu.
2
Double-click on the System icon to call up the
System Properties window.
3
Select the Hardware tab and click [Device Man-
ager].
4
Click on the [+] mark next to "Sound, video
and game controllers," and confirm that the
name of the mLAN device and "Yamaha mLan-
Bus" are listed.
When using Windows Vista
1
Select [Control Panel] from the Start menu.
2
Double-click the Device Manager icon.
NOTE
• If the "User Account Control" window appears, click [Con-
tinue].
3
Click on the [+] mark next to "Sound, video
and game controllers," and confirm that the
name of the mLAN device and "Yamaha mLan-
Bus" are listed.
NOTE
• The available mLAN devices are shown as follows:
mLAN device Indication
01X YAMAHA 01X-mLAN or
Yamaha 01X-mLAN
i88X YAMAHA i88X or Yamaha i88X
mLAN16E YAMAHA mLAN16E or
Yamaha mLAN16E
mLAN16E2 Yamaha mLAN16E2
MY16-mLAN YAMAHA MY16-mLAN or Yamaha
MY16-mLAN
n8/n12 Yamaha n series
Changing settings after
installation
NOTE
• If mLAN Driver is being used by an application (such as a DAW),
you cannot change the Sample Rate and Driver Setup settings. To
change the settings, first quit the application. If an error message
appears indicating that you cannot change a setting, refer to
page 21.

Sample Rate

(Right-click the driver icon on the task bar
ple Rate)
When using the mLAN connection set by Connection Man-
ager, this dialog box enables you to set the sampling frequency.
Click the down arrow in the Sample Rate field, then select the
desired sampling frequency. Click [OK] to apply the selec-
tion and close the dialog box. By clicking [Apply], your
selection will be applied and the dialog box will remain open.
While you are changing the sampling frequency, a window
appears indicating that the setting is being changed.
NOTE
• When using the n8/n12, the n8/n12 [COMP] indicator flashes
while you are changing the sampling frequency. For details, refer
to the n8/n12 owner's manual.
mLAN Driver/mLAN Tools Installation Guide
→
Sam-
13