Common Settings; First Page: Performance Name And Keyboard Playing Mode - Yamaha CP1 Owner's Manual

Common Settings

The Common Settings screen is used to set parameters affecting both Part 1 and Part 2, and it extends over four
individual pages.

First page: Performance name and keyboard playing mode

Press the [COMMON] button  Navigate to the first page using the [
Editing Sequence:
Name
Cursor
Data
KbdMode
(Keyboard Mode)
Point
ZoneEdit
This field contains the name of the current Performance. Names can be up to 10 characters in length, and
details on how they are set can be found in Setting Names from the Basic CP1 Operations section (see
page 25).
Knob 2 can be turned to move the cursor within the Name field.
Knob 3 can be turned to change the character at the current cursor position.
Setting values:
Lower case letters ............. abcdefghijklmnopqrstuvwxyz
Upper case letters ............ ABCDEFGHIJKLMNOPQRSTUVWXYZ
Numbers and symbols ...... 0123456789!"#$%&'()*+,-./:;<=>?@[ ? ]^_`{|} ?
This parameter is used to select a keyboard playing mode.
Setting values: layer, split, or zone
layer .............Part 1 and Part 2 both extend over the full length of the keyboard.
split...............Part 1 is used for all keys below that set using the Point parameter; Part 2 is used for the key
set using the Point parameter and all higher keys.
zone .............Four individual zones can be setup extending over sections of the keyboard, with Part1
playing on zone1, Part 2 playing on zone2, and external devices responding to notes from
zone3 and zone4. Each of these zones has a fixed MIDI channel (see page 52), allowing the
CP1 to operate as a master keyboard or to respond to MIDI messages send on these
channels. Accordingly, this mode should be selected whenever exchanging MIDI messages
with external MIDI devices.
NOTE The Utility screen is used to set MIDI-related parameters whenever KbdMode is set to "layer" or "split".
This parameter is used to set the point (or key) at which the keyboard is split between Part 1 and Part 2. As
such, it is displayed only when KbdMode has been set to "split".
Setting values: C -2 to G8
The ZoneEdit option is displayed only when KbdMode has been set to "zone", and if Knob 6 is pressed at
this time, the Zone Edit screen (see page 52) will be displayed.
Common Settings
PAGE] button  Turn Knobs 1 to 6
CP1 Owner's Manual
51