Changing The Initial Settings Of The Recorded Song; Deleting Recorded Data - Yamaha Arius YDP-164 Owner's Manual

Changing the Initial Settings of the Recorded Song

The settings of the following parameters can be changed after the Record operation is completed.
• For individual Parts: Voice, Volume balance (Dual/Duo), Reverb Depth, Damper Resonance
• For the entire Song: Tempo, Reverb Type
1.
Make settings for the above parameters as desired.
2.
While holding down [REC], press the desired Part button to
engage Record Ready mode.
The [REC], [PLAY] and selected Part ([+R] or [–L]) lamps flash.
In this status, do not press [PLAY] again or any key. Otherwise, the originally
recorded performance data will be deleted.
3.
While holding down [REC], press [PLAY] to exit from
Record Ready mode.
The [REC], [PLAY], [+R] and [–L] lamps flash. After the Save operation is
completed, the lamps will turn off, indicating that the operation has been
completed.
Confirm the setting by playing the Song.

Deleting Recorded Data

To delete the entire Song:
1.
While holding down [REC], press [DEMO/SONG].
The [REC] and [PLAY] lamps flash alternately.
To exit from this status, press [REC].
2.
Press [PLAY] to delete the data of the entire Song.
The [REC], [PLAY], [+R] and [–L] lamps flash.
After the operation is completed, all lamps turn off.
To delete a specific Part:
1.
While holding down [REC], press [+R] or [–L] (depending
on the Part you want to delete) to engage Record Ready
mode.
The [REC], [PLAY] and selected Part ([+R] or [–L]) lamps flash.
2.
Press [PLAY] to start recording without playing the
keyboard.
The selected Part ([+R] or [–L]) lamp flashes.
3.
Press [REC] or [PLAY] to stop recording.
All data recorded for the selected Part will be deleted, and the lamp turns off.
Recording Your Performance
NOTE
If a User Song has not been
recorded to the instrument, the
[REC] and [PLAY] lamps flash
quickly for about three
seconds.
YDP-164, YDP-144, YDP-S54 Owner's Manual
29