Yamaha CP5 Owner's Manual page 11

B3 C4 D4 E4 F4 G4 A4 B4
[STORE/ASSIGN] button (pages 28 , 50)
Press this button to call up a screen for storing Performances
and system settings. In addition, by pressing and holding
the [STORE/ASSIGN] button (for at least one second) within
the Performance screen or a parameter setting screen (for
any block other than the Master Equalizer or Master
Compressor), you can call up a screen for directly assigning
each of the Knobs 1 to 3 (see
[COMMON] button (page 35)
Press this button to open the parameter setting screen for
the Common Settings area, which affects each of the left and
right parts in the same way. The lamp to the top-left of the
button lights up whenever this screen is being displayed.
[PRE-AMP] button (pages 31, 34)
[MOD-FX] button (pages 31, 34)
[PWR-AMP] button (pages 31, 34)
[REVERB] button (pages 31, 35)
Press these buttons to toggle on and off the Pre-Amplifier
block, Modulation Effect block, or Power-Amplifier /
Compressor block (CP5 only) for currently-selected part or
the Reverb block. The lamp to the top-left of each button
lights up whenever the corresponding block is turned on. It
should be noted, however, that the Pre-Amplifier block has
an effect on the sound only if a voice from the PIANO or
E.PIANO category has been selected for the part in
question. Furthermore, if you press and hold one of these
buttons (for at least one second), the parameter setting
screen for the corresponding block will be displayed, and
C5 D5 E5 F5 G5 A5 B5 C6
below) to block parameters.
CP5 only
D6 E6 F6 G6 A6 B6 C7
the lamp to the top-left of the button will start to flash. Even if
a block's parameter setting screen is being displayed, it can
still be toggled on and off by pressing the corresponding
button. It should be noted that these lamps will flash in one of
two different ways to indicate whether the block is on or off;
specifically, the lamp stays lit longer when the block is on,
and it stays off longer when the block is off.
[SONG SETTING] button (page 37)
Press this button to open the Song Setting screen. The lamp
to the top-left of the button lights up whenever this screen is
being displayed.
[REC] button (page 41)
Press this button to open the Record screen. The lamp to the
top-left of the button lights up whenever this screen is being
displayed.
Sequencer Transport buttons (pages 37, 42)
Use these buttons to control the recording and playback of
backing tracks.
[ ] (Rewind) button
Whenever you are using a Preset Drum Pattern or a User
Song as the backing track, pressing this button will move the
play position back by one measure at a time. Alternatively, if
you are using a Wave file as the backing track, pressing this
button will move the play position back by one second at a
time. Press and hold the button to rewind continuously.
Control Panel
CP5/CP50 Owner's Manual
11