Advertisement
Prior to the first use of this appliance,
use all-
purpose
cleaning
products or a solution of detergent
and water, with damp cloth to remove from the
inside of the dryer drum!drying
compartment
any
dust or dirt that may have accumulated
inside the
dryer.
Plug-in your dryer after reviewing
the
following
parts on your dryer's
Electrical
Requirements.
Effective
dryer operation
requires appropriate
dryer
airflow. The adequacy
of the airflow can be
measured
by evaluating
the static pressure.
Static
pressure
in the exhaust
duct can be measured
with a
manometer,
placed on the exhaust
duct
approximately
2 ft. (60.9 cm) from the dryer.
Static
pressure
in the exhaust
duct should not exceed 0.6
inches (1.5 cm). The dryer should be checked
while
the dryer is running with no load.
Measuring Static pressure
Confirming
Heat Source
in Gas Dryers
Close the door to the dryer drum/drying
compartment
and, after completing
all steps in this
manual for proper installation
of this dryer, start the
dryer on a heat setting.
After the dryer starts, the
igniter will glow red and the main burner will
ignite.
Warning:
If all air is not purged from the gas line,
the gas igniter may go off before the gas and the
main burner have ignited.
If this happens,
the
igniter will re-attempt
gas ignition after
approximately
two minutes.
Confirming
Heat Source
in Electric
Dryers
Close the door to the dryer drum/drying
compartment
and, after completing
all steps in this
manual for proper installation
of this dryer, start the
dryer on a heat setting.
The exhaust air or the
exhaust pipe should be warm after the dryer has
been operating
for three minutes.
Exhaust
Duct
MAXIMUM STATIC
PRESSURE IN
WATER COLUMN
0.6 inche (1.5 cm)
Manometer
11
Advertisement
