Table of Contents
Advertisement
To install your new graphics card:
1. Locate the PCI Express x16 slot. If necessary,
remove the metal cover from this slot; then
align your graphics card with the PCI
Express x16 slot, and press it in firmly until
the card is fully seated.
* Please make sure that the gold edge connectors of the graphics card is securely inserted.
2. Replace the screws to fasten the card in
place, and replace the computer cover.
3. Plug the display cable into your graphics
card; then turn on the computer and monitor.
To connect a flat panel directly to your
graphics card, use the DVI-I connector. To
connect a VGA monitor to the DVI-I
connector, plug the DVI-I to D-sub adapter
into the DVI-I connector, then plug the monitor
cable into the adapter.
To TV / VCR
To Flat Panel Display
You are now ready to proceed with the installation of the graphics card driver. Please refer
to next chapter for detailed instructions.
After installation, please connect the power cable to your graphics card, or
the system will not boot.
- 7 -
Connect a flat panel
Connect a VGA monitor via DVI-I to D-sub adapter
Hardware Installation
Advertisement
Table of Contents
