Table of Contents
Advertisement
To install your new graphics card:
1. Locate two PCI Express x 16 slots. If
necessary, remove the metal covers from
the slots; then align your graphics card with
the PCI Express x 16 slots, and press it in
firmly until the card is fully seated.
* Please make sure that the gold edge connectors of the graphics card is securely inserted.
When installing the graphics card, do
not push down the heat pipe. This may
displace the heat pipe and cause bad contact
between the GPU and thermal pad as well as
affect the heat dissipation. To avoid system
instability, do not touch the graphics card when
it is runnnig .
2. Replace the screws to fasten the card in
place, and replace the computer cover.
3. Plug the display cable into your card; then
turn on the computer and monitor. If your
graphics card came with a DVI-I connector,
you can connect a flat panel display to the
appropriate connector, as shown below...
To TV / VCR
To Flat Panel Display
You are now ready to proceed with the installation of the graphics card driver. Please refer
to next chapter for detailed instructions.
To VGA Monitor
- 7 -
Hardware Installation
Advertisement
Table of Contents
