Lenovo ThinkServer RD240 User Manual page 49

4. Loosen the retaining screws on the front and rear of the riser card assembly. Then, remove the riser
card assembly from the server.
Note: If the riser card assembly is secured in place by a retaining latch
release the riser card assembly from the latch. Then, carefully pull the riser card assembly out of the
slot. If necessary, alternate moving each side of the riser card assembly a small and equal amount until
it is completely removed from the slot.
Figure 26. Removing the riser card assembly
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 71.
Installing the riser card assembly
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 19.
1 , press the retaining latch to
.
Chapter 5 Installing, removing, or replacing hardware
37