HP Vectra VL6 8 Installation Manual page 21

Windows NT Requirements
Workstation
• HP Vectra with Microsoft Windows NT Workstation 4.0 installed.
Version 4.0
• IBM AUTO LANStreamer PCI Drivers diskettes Ver. 3.04
• Driver Name for VL8 and VL7: OEMSETUP.inf Size: 67KB Date: 10/18/96.
• Driver Name for VE7/VE8: Streamer.sys Size: 85KB Date: 09/13/96.
• Microsoft Windows NT Workstation 4.0 and Service Pack Media.
• Microsoft Windows NT Server 3.51machine that supports Net BEUI, TCP/
Device Configuration
I/O Base Address
Interrupt Request
Procedure
1 With the HP Vectra turned off install the IBM LANStreamer 16/4 PCI TR
2 Insert the IBM LANStreamer TR drivers disk 2 of 5 (AUTO LANStreamer
3 After the machine boots, verify that the adapter finished testing and that
4 Click on "F3" to exit, and then press "CTRL+ALT+DEL."
5 After windows loads, log into NT workstation with administrator
6 Click on "Start", up to "Settings", and open "Control Panel."
7 Select the "Network" icon in the "Control Panel" program group.
8 Click on "YES" in the "Network Settings" dialog box, and NT Networking
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Vectra VL8
F800h
11
Level
adapter card into a PCI slot.
PCI Diagnostic Disk) and power on the machine.
the adapter is "OK."
privileges.
(If you do not have the required information, contact your network
administrator)
will be installed on your computer.
3 Connecting to a Windows NT Server 3.51
Windows NT Workstation Version 4.0
Vectra VL7 Vectra VE7/VE8
C800-h DC00-h
11 10(11)