HP Kayak XA-s02 User Manual page 42

geron.bk : geron-2.fb4 Page 30 Sunday, March 22, 1998 5:03 AM
Slide the memory module into the
o
slot at 90 to the system board
Push the module until the
retaining clips click into position
2 How to Install Accessories Inside Your PC Workstation
Installing Memory
4 Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation's case.
5 Remove the transparent airflow guide covering the processor
sockets (if needed).
6 Remove the floppy disk drive data cable from the system board.
7 The location of the memory module slots is shown here.
8 Slide the memory module into the slot at 90° to the system board
(with the cutouts furthest away from the processor).
30 English
Memory module
cutouts