Table of Contents
Advertisement
EPSON NX
If the computer has an Epson 170MB or 240MB hard disk
drive, select the appropriate type number from the table
below.
Epson Hard Disk Drive Types
Epson hard disk drive
28
3 4
lnstallation/Support Tips
Power
The computer has an input voltage selection switch on the
back panel to select between 115 VAC, for USA and
Canadian use, and 230 VAC, for use in other countries.
Mouse and Keyboard
When connecting the mouse and keyboard to the computer,
be careful to plug them into the proper ports. Although the
ports are physically identical, they are not interchangeable,
and you may damage the main system board if you plug the
connectors into the wrong ports.
Installing Diskette Drives
Make sure that the drive type has been correctly selected in
the SETUP program.
Installing Hard Disk Drives (for DOS Use)
It is recommended that a 16-bit, AT-type hard disk
controller be used if you are installing a drive that cannot
use the embedded IDE interface. If you install a non-IDE
hard disk drive and controller card, you need to use the
SETUP program to disable the built-in IDE hard disk
drive interface.
See the hard disk drive type tables on pages 7 and 8 and
use the SETUP program to enter the correct type
number(s) for the hard disk drive(s) installed in the
computer. (Also be sure to use the SETUP program to set
the hard disk drive configuration if you install or remove
a hard disk drive.) You can select a type number that
matches the parameters for the drive or a type number
with parameters having lesser values, as long as they do
not exceed the maximum capacity (in MB) of the drive. If
there is no match for the drive, you can press Enter and
then F2 at the Hard disk 1 or 2 option and enter the
drive's exact parameters.
Software Problems
only on a diskette or that requires a key disk, try to load
the program at high speed. If you can't load the program
at high speed, set the processor speed to automatic.
EPSON NX-8
require a key disk but requires a special procedure to
install it on a hard disk, set the speed to low while you
install the program. Then set the speed to high while you
load and run the program. If this does not work, try
installing and loading the program at low speed and then
change to high speed to run it.
program, the ESPEED program, or keyboard commands.
See the User's Guide
Password
Make sure that you do not forget the password you set. If
you do, you must disable it by setting jumper J13 on the main
system board to position A.
Information Reference List
Engineering Change Notices
None.
Technical Information Bulletins
None.
Product Support Bulletins
None.
Related Documentation
EPSON NX Parts Price List
PL-EPSNNX
EPSON NX Self Paced Kit
400227900
EPSON NX User's Guide
400227800
EPSON VGA Utilities Guide for Wingine
400193100
based products
6/30/93
and
for more information.
Setup Guide
Advertisement
Table of Contents
