Simm Lnstallation; Jumper Settings - Epson Powerspan Desktop Product Information Manual

EPSON PowerSpan DT
System board components and connectors
Monitor jumper
Setup entry/write-protect jumper
Keyboard connector
Speaker
JlF2
JlF3
Hard disk drive LED
I hb0LED
Auxiliary Ian
SIMM bank 1
SIMM bank 0
CPU clock speed jumper (DO NOT CHANGE SETTING)
Diskette drive connecfor
AT IDE hard disk drive connector
Power connector
BIOS
I FleaI-time clock
Processor

Jumper Settings

I
Jumper I
number Settings Function
l-2
2-3
l
4-5 Enable BIOS upgrades to tfte flash memory
Upgrades
l-2
Normal CMOS operation
l
2-3 Clear current CMOS settings to reset to the factory
default settings
4-5 Enable the current password
l
2-3 *
4-5
Enable entry Into the Setup program
l
5-6
Factory setting
l
EPSON PowerSpan DT - 4

SIMM lnstallation

Your computer comes with 8MB of memory on two 4MB
SIMMs. You increase the memory up to 128MB using
can
1MB, 2MB, 4MB, 8MB, 16MB, and 32MB SIMMs (when
readily available).
The SIMM sockets are organized in two banks (Bank 0 and
Bank 1) consisting of two sockets each. You must install the
same type of SIMM in a bank.
The SIMMs you install must be 32-bit or 36-bit, 72-pin, 70ns,
tin-plated, fast-page mode, parity/no parity DRAM. The
table below lists the 16MB and 32MB SIMMs that are
approved for use in your system. You can install these
SIMMs or their equivalents.
Manufacturer
Samsung
Samsung
Hitachi
The table below lists possible combinations of SIMMs you
can install; do not use any configuration other than one of
those listed in the table.
SIMM configurations
I
3/94
Description
Part number
16MB; with parity
KM41 COOBJ-7
16MB; no parity
KMM5324000BG-7
32MB; with parity HM5117400J7