NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual page 41

• Disable
• Allow
• Block
Then, enter the MAC address for a device you plan to use. You can usually find the MAC
3.
address printed on the wireless adapter.
You can copy and paste the MAC addresses from the WG602 v2's Station List page into the
MAC Address box. To do this, configure each wireless PC to obtain a wireless link to the
WG602 v2. The PC should then appear in the Station List page.
Click Add to add the wireless device to the access list. Repeat these steps for each additional
4.
device you want to add to the list.
Be sure to click Apply to save your wireless access control list settings.
5.
Now, only devices on this list will be allowed to wirelessly connect to the WG602 v2. For blocking
access from specific devices, follow the procedure above, except select the Block radio button.
Basic Installation and Configuration
Reference Manual for the WG602 v2 54 Mbps Wireless Access Point
M-10181-03
3-18