Default Factory Settings - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

For best results, place your wireless access point:
• Near the center of the area in which your PCs will operate.
• In an elevated location such as a high shelf where the wirelessly connected PCs have
line-of-sight access (even if through walls).
• Away from sources of interference, such as PCs, microwaves, and 2.4 GHz cordless phones.
• Away from large metal surfaces.
• If using multiple access points, it is better if adjacent access points use different
Channels to reduce interference. The recommended Channel spacing between adjacent access
points is 5 Channels (for example, use Channels 1 and 6, or 6 and 11).
The time it takes to establish a wireless connection can vary depending on both your security
settings and placement.

Default Factory Settings

When you first receive your WG602 v2, the default factory settings will be set as shown below. To
restore these defaults, see
User Name (case sensitive)
Password (case sensitive)
Access Point Name
if DHCP server is unavailable
Wireless Mode (Access Point or Bridge)
Wireless Network Name (SSID)
Broadcast Network Name
Radio Frequency Channel
Authentication Type
Basic Installation and Configuration
Reference Manual for the WG602 v2 54 Mbps Wireless Access Point
"WG602 v2 Wireless Access Point Rear Panel" on page
FEATURE FACTORY DEFAULT SETTINGS
admin
password
NETGEARxxxxxx where xxxxxx are the last six digits of
the wireless access point's MAC address
DHCP DHCP client
IP Configuration IP Address: 192.168.0.227
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Access Point
NETGEAR
Enabled
802.11g/b 11
WEP/WPA Disabled
Auto
M-10181-03
radio frequency
2-6.
3-2