Yamaha S08 Voice Editor Manual page 10

3 "Editor Setup" button
Click this to open the "Editor Setup" dialog and specify the MIDI Out port settings.
"Editor Setup" Dialog
This is where you set up the Voice Editor to allow the transmission of voice data to your
synthesizer. Click the [OK] button to apply the settings and quit the dialog. Click the [Cancel]
button to quit without applying the settings.
1 "MIDI In Port:" ..........Click this and choose the MIDI In port. This allows you to receive
2 "MIDI Out Port:" .......Click this and choose the MIDI Out port. You can use the Voice
n
If you are using a Macintosh, the MIDI Out Port setting is assigned in the OMS Port Setup. For
further details, see section "OMS Settings."
3 "MIDI Ch:".................Click this and choose the MIDI Out channel. This is used when
4 "Device No.:"............Click this and choose the MIDI device number of your synthesizer.
5 "Dump Interval:" ......Click this and choose the interval between successive MIDI
n
If you set too short an interval, you may encounter errors when transmitting MIDI data.
1
2
3
4
5
data from a device connected to this port. Select the port which
has been assigned to your particular synthesizer within the host
application.
Editor to control and edit the device connected to this port. Select
the port which has been assigned to your synthesizer within the
host application.
monitoring sounds using the on-screen keyboard in the Edit
Windows.
dumps.
(page 23)
10