Inserting Remote Control Batteries; Demo/Dimmer Function; Setting The Clock - Samsung MAX-S530 Instruction Manual

MAX-S520/S530(GB)R1~14

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
ment cover (rear of the remote control) and push the cover in the
direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
3
Replace the cover by sliding it back until it clicks into position.

Demo/Dimmer function

All functions available on the system can be viewed on the
display and the display's brightness can be switched between
"on" and "off".
1
Press the Demo/Dimmer button.
Result: All functions available on the system appear on the front
panel display.
Each of these are explained in detail in this guide. Please refer to
the relevant section.
2
Press the Demo/Dimmer button again.
Result: The Dimmer function is selected and the display darkens.
3
Press the Demo/Dimmer button once again to brighten the front
panel display.
A display brightness control can only be performed while the
system power is on.
2/17/03 18:38 Page 9
on the battery compart-

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1
Switch the system on by pressing Standby/on.
2
Press Timer/Clock twice.
Result: CLOCK is displayed.
3
Press Enter.
Result: The hour flashes.
4
To... Press the...
Increase the hours Tuning Up
Decrease the hours Tuning Down
5
When the correct hour is displayed, press Enter.
Result: The minutes flash.
6
To... Press the...
Increase the minutes Tuning Up
Decrease the minutes Tuning Down
7
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control
to instead Enter button in step 3,5,7.
1
2
3,5,7
4,6
4,6
9
GB