Motorola ST8600 Manual page 144

Troubleshooting
Q. I tried to place a call and received a fast busy signal.
A. This sound means that the cellular system did not process your call. For example,
the cellular system may be overloaded with call attempts. To redial the number,
press before ending your call attempt, or press
again later. (See page 36 for more information on redialing.)
Q. I tried to place a call and received an alternating high/low tone.
A. This sound means your call did not reach the cellular system. Most likely, you
dialed the number too soon after turning the phone ON. Wait until the red NS
light stops blinking before placing a call.
An alternating tone may also indicate that your phone's signal is blocked. Make
sure the antenna is fully extended and move clear of any obstructions, like
bridges, parking garages, tall buildings, etc.
Q. My phone started beeping and the display says: "
A. This sound means that someone tried to call you while you were in an area where
the cellular signal was weak. Press
phone's antenna and avoid obstructions like tunnels, parking garages and tall
buildings whenever possible.
Q. I am in my home service area but the Roam indicator is flashing.
A. If your phone is programmed with more than one telephone number, you might
not have switched to the number appropriate for your current location. Press
,
(See page 102 for more information on multiple phone numbers.)
144
, to switch to your other number.
" What happened?
Call 01.
to clear your display, extend your
and try the call