Motorola SELECT 6000 Manual page 14

Table of Contents

Advertisement

Charging Your Battery While Traveling
Your travel charger can be connected directly to your phone for
convenient rapid battery charging.
1
Fit the battery to your phone.
2
Connect the travel charger to the base of your phone (see
diagram).
3
The phone automatically enters charging mode when the
travel charger is attached. The q symbol flashes while the
battery is being charged.
When the phone is charging and turned off, the charging status will
be continuously displayed. Press E4 to display charging
status while the phone is on.
12
About Your Phone, Battery and SIM Card
When the battery is about 95% charged, the message
will be displayed and the q symbol will
Charge Complete
stop flashing.
If the display is completely blank when the travel charger is
A
connected, the battery is not being charged.
Typical charge times for achieving a 95% charge level using the
Rapid travel charger are as follows:
Battery Type
Slim 560 mAh NiMH
Slim 400 mAh Li-Ion
Slim Extra Cap 900 mAh Li-Ion
Extra Capacity 1300 mAh NiMH
Extra Capacity 1200 mAh Li-Ion
! The battery will continue to slow charge until fully charged.
Do not leave a NiCd or NiMH battery connected to the travel
charger for more than 24 hours.
Fast
Charge Time
Part Number
55 minutes
SNN 4615
4 hours
SNN 4555
4 hours
SNN 4698
2 hours
SNN 4258
4 hours
SNN 4459

Advertisement

Table of Contents
loading

This manual is also suitable for:

Microtac select 6000e

Table of Contents