Specifications - Kenwood KTF-2010 Instruction Manual

Specifications

KTF-2010
FM tuner section
Tuning frequency range ......................... 87.5 MHz ~ 108 MHz
Usable sensitivity (DIN)
MONO ....... 1.3µV(75 )/13.5 dBf(40 kHz dev., S/N 26 dB)
STEREO ..... 50µV(75 )/45.2 dBf(46 kHz dev., S/N 46 dB)
Limiting level (DIN) ................................ 1.0µV(75 )/11.2 dBf
Total harmonic distortion (DIN at 1 kHz)
MONO .............................................. 0.1 % (65.2 dBf input)
STEREO ........................................... 0.3 % (65.2 dBf input)
Signal to noise ratio
(DIN weighted at 1 kHz, 40 kHz dev.)
MONO ............................................. 69 dB (65.2 dBf input)
STEREO .......................................... 61 dB (65.2 dBf input)
Stereo separation (DIN)
1 kHz ........................................................................... 45 dB
Capture ratio .................................................................. 2.0 dB
Selectivity (DIN ±300 kHz) .............................................. 60 dB
Image rejection ratio (at 98MHz) ................................... 80 dB
IF rejection ratio (at 98MHz) ......................................... 100 dB
Spurious rejection ratio (at 98MHz) ............................ 100 dB
AM suppression ratio ..................................................... 68 dB
Sub carrior suppression ratio (DIN) ............ 55 dB (at 19 kHz)
Frequency response
(30 Hz ~ 15 kHz) ....................................... +0.5 dB, –2.0 dB
Output level / impedance (FM at 1 kHz, 75 kHz dev.)
Fixed ............................................................... 0.6 V/1.3 k
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed with-
out notice.
Note Note
2. The full performance may not be exhibited in extremely coud location (under a water-freezing temperature).
MW (AM) tuner section
Tuning frequency range .......................... 531 kHz ~ 1,602 kHz
Usable sensitivity
Signal to noise ratio
Total harmonic distortion ................................................ 0.4 %
Image rejection ratio ....................................................... 30 dB
Selectivity ......................................................................... 30 dB
Output level / impedance
LW (for U.K. only) tuner section
Tuning frequency range ............................. 153 kHz ~ 279 kHz
Usable sensitivity
Signal to noise ratio
Total harmonic distortion ................................................. 0.6%
Image rejection ratio ........................................................ 27 dB
Selectivity ......................................................................... 33 dB
65 dB (at 38 kHz) Output level/impedance
GENERAL
Power consumption .......................................................... 10 W
Dimensions ......................................... W : 440 mm (17-5/16")
Weight (net) ...................................................... 3.3 kg (7.26 lb)
(at 30 % mod., S/N 20 dB) .................... 12 µV/(400 µV/m)
(at 30 % mod., 1mV input) ......................................... 50 dB
(at 30 % mod., 1mV input) .......................... 0.18 V/1.3 k
(at 30% mod., S/N 20 dB) .......................................... 22µV
(at 30% mod., 1mV input) ...........................................47dB
(at 30% mod., 1mV input) ............................ 0.18 V/1.3 k
KTF-3010/KTF-2010 (En)
17
H : 94 mm (3-11/16")
D : 384 mm (15-1/8")