Edelbrock 65232 Installation Instructions

Please study these instructions carefully before installing your new Headers. If you have any questions, please contact our Technical
Hotline at : 1-800-416-8628 from 7 am – 5 pm, Monday through Friday, Pacific Standard Time or e-mail us at
Edelbrock@Edelbrock.com.
DESCRIPTION: These components are designed to improve the exhaust efficiency of the Ford 5.4 Litre V8 engine. This system does
not require welding for installation and retains all O.E.M. emissions equipment. These Edelbrock headers are street legal in all 50
states. These systems should be installed by an experienced/qualified mechanic.
Suggested tools needed for installation: This vehicle has some metric fasteners.
❑ 3/8" ratchet socket set with extensions and universal 13mm and 15mm swivel sockets
❑ Combination set of open-end wrenches
❑ Jackstands, screwdrivers, pliers, crescent wrench, etc.
❑ Liquid penetrant, (GM #1052627) anti-seize compound (GM #5613695)
❑ 13mm open end wrench (stubby)
❑ 1/4" ratchet socket set with extensions and swivel
❑ 5mm and 10mm socket
SPECIAL NOTICE: This Edelbrock part has received an Executive Order number (E.O. #) from the California Air Resources Board
(C.A.R.B.) making it legal for street use on pollution-controlled motor vehicles in all 50 states. To assist you with emissions equipment
certification, we have included a silver fan shroud decal to help testing personnel verify that this part is a legal replacement part on
the vehicle for which it is cataloged. The adhesive-backed decal should be affixed to your fan shroud next to the existing emission
and engine specification decal. Do not cover your original equipment specification decal with the Edelbrock fan shroud decal.
WARNING: The use of "Thermal Wrap" or any aftermarket coating process will void the warranty on your Headers. Those products
can cause excessive heat and moisture build up resulting in corrosion and early failure of the system.
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in
DISASSEMBLY:
1. Disconnect negative battery cable.
2. Raise truck and support with jackstands. Disconnect
and remove O2 sensors from exhaust pipes.
3. Remove exhaust pipes from both left and right
manifolds.
4. Removal of front tires will make installation much
easier.
5. Remove both left and right plastic fender wells.
6. Disconnect and remove starter from vehicle.
©2007 Edelbrock Corporation
Catalog #65232 & #65233
For 2004-2007 Ford F-150, and 2007 Expedition,
IMPORTANT NOTE:
poor performance and engine or vehicle damage.
INSTALLATION INSTRUCTIONS
Page 1 of 2
Catalog #65232 & #65233
INSTALLATION INSTRUCTIONS
LEFT SIDE
1. Remove nuts and studs from manifold.
2. Remove stock manifold and gasket from vehicle
through wheel well.
3. Install port flange gasket and 8mm bolts, lock
washers, and flat washers on all lower bolt holes.
Leave bolt loose enough to accept header.
4. Place header into position through wheel well. Install
using supplied bolts, lockwashers and hardened
washers, then tighten evenly. NOTE: Use anti-seize
compound on all bolts.
Edelbrock Headers
5.4L V8 2WD & 4WD
Brochure #63-65232
Rev. 2/07 - DA/mc