Kenwood HM-L700 Instruction Manual page 13

Basic operations in the setting mode
Settings and adjustments are made using the
MODE key. Press the MODE key to get the setting
mode. Make settings with the 4 and ¢ keys.
Use the ENTER key to enter settings.
\
\
• When the MODE key is pressed followed by the 4
and ¢ keys, the display changes as follows.
"TIMER SET"
"AUTO MEMORY "
(Only when the TUNER input is selected)
"AUX INPUT"
(Only when the AUX input is selected)
"BALANCE"
"A.P.S. SET"
"DISPLAY SET"
"TIME ADJUST"
Operation
After plugging the power cord of this unit, press the
key of the remote control unit to turn the system
ON. When the system is turned ON, press the key
of the function to be operated.
÷ When pressing more than one remote control keys
successively, press the keys securely by leaving an in-
terval of 1 second or more between keys.
Changing the battery of the remote control unit
Use a commercially available button battery (CR2025).
1
Insert something narrow like a paperclip into the hole 1
and pull out the battery tray.
÷ The provided battery is intended for use in operation checking, and its service life may be short.
÷ When the remote controllable distance becomes short, replace the battery with a new one.
÷ If direct sunlight or the light of a high-frequency fluorescent lamp (inverter type, battery etc.) is incident a new one to
the remote sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
\
\
• The setting next to ">" is the selected item.
Example: When "ON" is selected
• If an operation is not performed for 20 sec or more, the
setting mode is automatically canceled. (TIME ADJUST
and TIMER SET excluded)
Operating range (approx.)
Remote sensor
6 m
30˚
2
Replace the old battery with
a new one.
Load the battery in the right direction.
Controls and indicators System connection
30˚
CR2025
(+ side)
13
EN