Table of Contents
Advertisement
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89 KDC-CPS87,
KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is
connected, the Auxiliary input is entered when switching modes.
The following messages are displayed when your
system condition.
EJECT:
No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
NO DISC:
No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
E-04:
No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
Clean the CD and load it correctly.
BLANK:
Nothing has been recorded on the MD.
NO TRACK:
No tracks are recorded on the MD, although it has a
title.
E11
NO PANEL:
The faceplate of the slave unit being connected to
this unit has been removed.
Replace it.
E-77:
The unit is malfunctioning for some reason.
Press the reset button on the unit. If the "E- 77"
code does not disappear, consult your nearest
service center.
E-99:
HOLD:
E01
NO NAME:
NO TITLE:
E02
NO TEXT:
E04
LOAD:
2 3
E10
NO ACCES:
E30
E77
— 31 —
Something is wrong with the disc magazine. Or the
unit is malfunctioning for some reason.
Check the disc magazine. And then press the reset
button on the unit. If the "E-99" code does not
disappear, consult your nearest service center.
The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
Attempted to display DNPS during the CD play having
no disc names preset.
Attempted to display the disc title or track title while
the MD having no MD title is being played.
Attempted to display the disc text or track text while
the CD having no CD text is being played.
Discs are being exchanged in the Disc changer.
(Blink):
The tape player section is not operating properly.
Reinsert the Tape. If the tape cannot be ejected or
the display continues to flash even when the tape
has been properly reinserted, please switch off the
power and consult your nearest service center.
After setting it in the Disc Changer, DNPP was done
without having it been played at least 1 time.
E99
E0d
E51
E53
E54
E57
E60
E58
Advertisement
Table of Contents
